I have completed the build table and drawn out the plan of the lower rails.  Had quite a job getting the top flat, not as easy as you may think. Its on wheels, so when I am finished work for the day I can easily move it to get the car into the garage.

The work bench is finished and I have started on the build table (see photo below).

There have been some major changes to my clubbie plans. I have made the following decisions:

Chassis: As close as possible to the design in the Chris Gibb’s book

Engine: Mazda/Ford 2 litre MZR/Duratec (from a Ford Focus or Mazda 3)

Gearbox: Mazda RX-7

Front End: Gemini

Rear End: IRS with Subaru diff